TC-160 LIGHTNING 12V ELECTRIC UNDER TAILGATE SPREADER. All TruckCraft spreaders carry a two year limited factory warranty. Made of tough, corrosion resistant 6061 T6 Aluminum alloy and stainless steel you get the best of both worlds, weight savings and extreme durability in high-salt conditions. And check out innovative designs by TruckCraft, such as the completely enclosed 90 degree-angled gear reducer on the SPINNER DRIVE. It not only provides maximum road clearance by positioning the motor up, horizontally, but the 2:1 gear reduction doubles torque, allowing you to slow the spinner down without sacrificing torque. Heavy, factory assembled wiring harnesses carry power from the USA-made Electronic Control Unit to the enclosed, LEESON® Wash-Down-Grade motors, made with type 304 stainless shafts, double seals, epoxy coating, and sealed housings. It doesn’t get any beefier than this. See one at your local TruckCraft dealer now!

  • All electric – needs no hydraulic system
  • 3/4 HP auger drive empties 15,000 lb/hr*
  • 1/6 HP spinner motor in protected housing
  • Mounting kit fits virtually any one-ton dump body
  • Constructed of extruded 6061 T-6 alloy & 5052-H32 aluminum sheet for durability
  • Installed unit weight – 313lbs
  • Backlit, fused, 100 AMP motor controller- U.S. made*
  • Auto-level spinner requires no linkage
  • Right angle spinner motor drive provides higher motor road clearance
  • Stainless steel 5″ auger, 12″ spinner plate, and all hardware
  • All bolt-on kit installs in 5 hours
  • Auger reducer is in-line premium helical gear type for 98% efficiency
  • Spreads free-flowing mat’l up to 3/4″ dia.
  • Two year factory Limited warranty (excluding wear items)
  • *150 AMP Alternator recommended for 15,000# output